Installing An Mx960 Dual-Wide Mic; Figure 100: Removing The Septum - Juniper MX960 Hardware Manual

Installing an MX960 Dual-Wide MIC

Copyright © 2017, Juniper Networks, Inc.
To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX960 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum towards you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.

Figure 100: Removing the Septum

Remove four screws
on bottom.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
3.
on the faceplate. Install a cap if necessary.
Pull the ejector lever above both MIC slots away from the router.
4.
Align the rear of the MIC with the guides located at the corners of the MIC slot.
5.
Slide the MIC into the MIC slot until it is firmly seated in the chassis.
6.
Figure 101 on page 283):
Figure 100 on page
377).
on the bottom of the MPC.
S
on the top of the MPC.
S
"Installing an MX960 MPC" on page
Remove two
screws on top.
Slide septum
forward.
MPC
Chapter 21: Installing Components
281):
284.
281