Installing An Mx2020 Dual-Wide Mic - Juniper MX2020 Hardware Manual

Figure 243: Installing a MIC
0
SEE ALSO
Prevention of Electrostatic Discharge Damage | 770
Removing an MX2020 MIC | 553

Installing an MX2020 Dual-Wide MIC | 558

Installing an MX2020 Dual-Wide MIC
To install a dual-wide MIC:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the septum, if necessary (see
a. Place the MPC on a flat surface. If necessary, remove the MPC from the ADC as described in
"Removing an MX2020 MPC from the Adapter Card" on page
b. Remove the four screws labeled S on the bottom of the MPC.
c. Remove the two screws labeled S on the top of the MPC.
d. Slide the septum toward you and out of the MPC.
19
Figure 244 on page 559):
539.
558