MX2020 3D Universal Edge Router Hardware Guide
Removing the MX2020 Upper Cable Manager
Installing the MX2020 Upper Cable Manager
306
Removing the MX2020 DC Cable Manager on page 309
5.
Installing the MX2020 DC Cable Manager on page 310
6.
To remove the upper cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the upper cable manager cover, and remove it.
2.
Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the
3.
upper cable manager.
Grasp the upper cable manager, and pull it straight out from the studs on the front of
4.
the chassis.
Figure 142: Removing the Upper Cable Manager
To install the upper cable manager (see
Position the upper cable manager on the studs on the upper front of the chassis, just
1.
below the craft interface.
Insert the screws into the corners in the upper cable manager onto the studs on the
2.
chassis.
Using a Phillips (+) screwdriver (number 1 or 2), tighten the mounting screws securely.
3.
Replace the cable manager cover, and secure the two captive screws.
4.
Figure 142 on page
306):
Figure 143 on page
307):
Copyright © 2013, Juniper Networks, Inc.