Removing A Management Ethernet Cable; Installing A Management Ethernet Cable - Juniper ACX500 Hardware Manual

Installing a Management Ethernet Cable | 190

Removing a Management Ethernet Cable

To remove a serial cable connected to a management device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Press the tab on the connector, and pull the connector straight out of the MGMT port.
shows the connector.
3. Disconnect the cable from the network device.
Figure 70: Ethernet Cable Connectors
Installing a Management Ethernet Cable
To install a serial cable connected to a management device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Plug one end of the replacement cable into the appropriate MGMT port.
3. Plug the other end of the cable into the network device.
RELATED DOCUMENTATION
Management Port Connector Pinout Information for ACX500 Routers | 104
190
Figure 2