T4000 Core Router Hardware Guide
Removing the T4000 Front Cable Management System
156
Figure 47: Removing the Rear Fan Tray
The front cable management system is located below the FPC card cage. The cable
management system weighs approximately 5 lb (2.3 kg).
To remove the front cable management system:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Using a 3/8-in. nut driver, unscrew the nuts on the corners of the cable management
2.
system.
Grasp the bottom of the cable management system, and pull it straight out from the
3.
studs on the front of the chassis.
Copyright © 2018, Juniper Networks, Inc.