Replacing An M10I Pic Cable; Removing An M10I Pic Cable - Juniper M10i Hardware Manual

Replacing an M10i PIC Cable

Removing an M10i PIC Cable

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Connecting M10i PIC Cables on page 63
M10i PICs Description on page 8
Maintaining the M10i PICs and PIC Cables on page 81
Troubleshooting the M10i PICs on page 94
Removing and installing PIC cables does not affect router function, except that a PIC
does not receive or transmit data while its cable is disconnected.
Removing an M10i PIC Cable on page 115
1.
2. Installing an M10i PIC Cable on page 116
To remove a PIC cable:
If the PIC connects to fiber-optic cable, have ready a rubber safety cap for each cable
1.
and transceiver.
If removing all cables connected to the PIC, use one of the following methods to take
2.
the PIC offline:
Press and hold the PIC offline button until its failure indicator LED lights, which
usually takes about 5 seconds. The failure LED is usually red; for more information,
see the M10i Multiservice Edge Router PIC Guide. The offline button for each PIC is
located on the HCM and is labeled with the PIC slot number. The PICs in FPC
located on the upper HCM, and the PICs installed in FPC
HCM.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
For more information about the command, see the Junos OS System Basics and
Services Command Reference.
Unplug the cable from the cable connector port. If the PIC uses fiber-optic cable,
3.
immediately cover each transceiver and the end of each cable with a rubber safety
cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 15: Replacing M10i Hardware Components
1 are located on the lower
0 are
115