Tools And Parts Required To Replace Mx480 Hardware Components - Juniper MX480 Hardware Manual

Tools and Parts Required to Replace MX480 Hardware Components

To replace hardware components, you need the tools and parts listed in
Table 100: Tools and Parts Required
Tool or Part
2.5-mm flat-blade (–) screwdriver
7/16-in. (11 mm) nut driver or
socket wrench
Blank panels (if component is not
reinstalled)
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD)
grounding wrist strap
Flat-blade (–) screwdriver
Components
Alarm relay terminal block
DC power supply
Cables and connectors
DPC
FPC
PIC
MPC
MIC
Power supply
Routing Engine
SCB
Craft Interface
DPC
FPC
PIC
MPC
MIC
Routing Engine
SCB
All
DPC
Cables and connectors
Table 100 on page 281.
281