Tools And Parts Required To Replace Mx240 Hardware Components; Table 93: Tools And Parts Required To Replace Hardware Components - Juniper MX240 Hardware Manual

See Also

Tools and Parts Required to Replace MX240 Hardware Components

Copyright © 2019, Juniper Networks, Inc.
MX240 Host Subsystem Description on page 58
Taking an MX240 Host Subsystem Offline
To replace hardware components, you need the tools and parts listed in
Table 93 on page 219.
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters

Table 93: Tools and Parts Required to Replace Hardware Components

Tool or Part
2.5-mm flat-blade (–) screwdriver
7/16-in. nut driver or socket wrench
Blank panels (if component is not
reinstalled)
Chapter 4: Maintaining, Installing and Replacing Components
Components
Alarm relay terminal block
Cables and connectors
DC power supply
DPC
FPC
MIC
MPC
PIC
Power supply
Routing Engine
SCB
219