Mx104 Ac Power Cord Specifications - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide
Related
Documentation

MX104 AC Power Cord Specifications

160
Table 24: AC Power Electrical Specifications (continued)
Item
AC input line frequency
AC input current rating
Efficiency
Maximum AC power supply
output power
System
Maximum output power
NOTE: We recommend that you use a facility circuit breaker rated for 10 A
maximum per inlet at 100 VAC to 240 VAC. Doing so enables you to operate
the router in any configuration without upgrading the power infrastructure,
and allows the router to function at full capacity using multiple power
supplies.
Connecting AC Power Cords to the MX104 Router on page 53
Replacing an MX104 AC Power Supply on page 96
MX104 AC Power Electrical Safety Guidelines and Warnings on page 141
MX104 AC Power Cord Specifications on page 160
Each AC power supply has a single AC appliance inlet that requires a dedicated AC power
feed. Most sites distribute power through a main conduit that leads to frame-mounted
power distribution panels, one of which can be located at the top of the rack that houses
the router. An AC power cord connects each power supply to the power distribution panel.
You can order detachable AC power cords, each approximately 8 ft (2.5 m) long that
supply AC power to the router. The C15 appliance coupler at the female end of the cord,
as described by International Electrotechnical Commission (IEC) standard 60320, inserts
into the AC appliance inlet coupler. The plug at the male end of the power cord fits into
the power source receptacle that is standard for your geographic location.
Table 25 on page 161 provides specifications on the AC power cord provided for each
country or region.
Specification
50 to 60 Hz (nominal)
10 A maximum per inlet at 100 VAC
91% @ 800 W@ 230 V
800 W
800 W
Copyright © 2014, Juniper Networks, Inc.