Table of Contents
Advertisement
14–16
51.
INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSY
(a)
Install a new O–ring to the camshaft timing oil control valve.
(b)
Install the camshaft timing oil control valve with the bolt.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
Straight Pin
Key Groove
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
ENGINE MECHANICAL
–
PARTIAL ENGINE ASSY (1ZZ–FE/3ZZ–FE)
52.
INSTALL CAMSHAFT TIMING GEAR ASSY
(a)
Put the camshaft timing gear assembly and the camshaft
together with the straight pin off the key groove.
(b)
Turn the camshaft timing gear assembly to the left direc-
tion (as shown in the illustration) with pushing it lightly
against the camshaft. Push further at the position where
the pin gets into the groove.
CAUTION:
A62824
Be sure not to turn the camshaft timing gear to the retard
angle side (to the right angle).
(c)
Check that there is no clearance between the gear's
fringe and the camshaft.
(d)
Tighten the fringe bolt with the camshaft timing gear fixed.
Torque: 54 N m (551 kgf cm 40 ft lbf)
(e)
Check that the camshaft timing gear assembly can move
to the retard angle side (the right angle), and is locked at
the most retarded position.
53.
INSTALL CAMSHAFT TIMING GEAR OR SPROCKET
(a)
Grip the camshaft with a vice, and install the camshaft tim-
ing gear.
Torque: 54 N m (551 kgf cm 40 ft lbf)
NOTICE:
Be careful not to damage the camshaft.
A32167
54.
INSTALL CAMSHAFT
(a)
Apply light coat of engine oil on the camshaft journals.
(b)
Place the 2 camshafts on the cylinder head with the No.
1 cam lobes facing as shown the illustration.
A62150
http://vnx.su
Advertisement
Table of Contents
