Toyota Avensis ZZT251 2003 Service And Repair Manual page 641

91. REMOVE KNOCK SENSOR
(a) Remove the nut and the knock sensor.
92. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
(a) Using SST, remove the engine coolant temperature sensor.
SST 09817–33190
93. REPLACE PARTIAL ENGINE ASSY
94. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the engine coolant temperature sensor.
(b) Install the engine coolant temperature sensor.
Torque: 20 N m (208 kgf cm, 15 ft lbf)
SST 09817–33190
95. INSTALL KNOCK SENSOR
Torque: 20 N m (208 kgf cm, 15 ft lbf)
96. INSTALL ENGINE OIL PRESSURE SWITCH ASSY
(a) Clean the threads of the oil pressure switch, apply adhesive there.
Adhesive: Part No. 08833–00080 THREE BOND 1344 or equivalent
(b) Install the oil pressure switch.
Torque: 15 N m (153 kgf cm, 11 ft lbf)
97. INSTALL WATER BY–PASS PIPE NO.1
(a) Install a new gasket and the water by–pass pipe No. 1 with the bolt and 2 nuts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
98. INSTALL FUEL DELIVERY PIPE W/INJECTOR
99. INSTALL DRIVE SHAFT BEARING BRACKET
Torque: 54 N m (551 kgf cm, 40 ft lbf)
100. INSTALL V–RIBBED BELT TENSIONER ASSY
Torque: 60 N m (607 kgf cm, 44 ft lbf)
101. INSTALL IGNITION COIL ASSY
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
102. INSTALL THERMOSTAT
103. INSTALL WATER INLET
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
2
4
1
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(See page 16–23)
104. INSTALL EXHAUST MANIFOLD CONVERTER
SUB–ASSY
(a) Install a new gasket and the exhaust manifold converter
3
with the 5 nuts.
Torque: 37 N m (378 kgf cm, 27 ft lbf)
5
A77332
http://vnx.su
– PARTIAL ENGINE ASSY (1AZ–FE)
(See page 11–26)
14–129