Toyota Avensis ZZT251 2003 Service And Repair Manual page 1074

5. REMOVE BRAKE ACTUATOR ASSY
(a) Remove the 2 nuts and brake actuator from the brake acutuator bracket.
6. REMOVE SKID CONTROL ECU
(a) Disconnect the connector from the skid control ECU.
(b) Using a torx driver (T20), remove the 4 screws and the skid control ECU from the brake actuator.
7. INSTALL SKID CONTROL ECU
(a) Install the skid control ECU and 4 screws with a torx driver (T20).
(b) Connect the connector to the skid control ECU.
8. INSTALL BRAKE ACTUATOR ASSY
(a) Install the brake actuator with the 2 nuts to the brake actuator bracket.
Torque: 7.0 N m ( 71 kgf cm, 62 in. lbf)
To Master Cylinder Front
To Front Wheel LH
To Rear Wheel RH
To Master Cylinder Rear
To Rear Wheel LH
To Front Wheel RH
10. INSTALL FRONT FENDER LINER RH
11. INSTALL FRONT WHEEL RH
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
12. FILL RESERVOIR WITH BRAKE FLUID
13. BLEED MASTER CYLINDER
SST 09023–00100
14. BLEED BRAKE LINE
15. CHECK FLUID LEVEL IN RESERVOIR
16. CHECK BRAKE FLUID LEAKAGE
17. CHECK BRAKE ACTUATOR WITH HAND–HELD TESTER
AVENSIS REPAIR MANUAL (RM1018E)
BRAKE
9. INSTALL BRAKE ACTUATOR WITH BRACKET
(a) Install the brake actuator with bracket with the nut and 2
bolts.
Torque: 19 N m (194 kgf cm, 14 ft lbf)
G24213
(b) Using SST, connect each brake line to the correct position
of the brake actuator, as shown in the illustration.
SST
Torque:
A: 15 N m (155 kgf cm, 11 ft lbf)
(c) Connect the brake actuator connector.
G24212
(See page
(See page 32–4)
(See page 32–4)
(See page
http://vnx.su
– BRAKE ACTUATOR ASSY (W/O VSC)
09023–00100
32–4)
32–4)
(See page
32–55
05–699)