Toyota Avensis ZZT251 2003 Service And Repair Manual page 1194

42–14
7. REMOVE CLUTCH MASTER CYLINDER ASSY
(a) Remove the 2 nuts clutch master cylinder assy and gasket.
8. INSTALL CLUTCH MASTER CYLINDER ASSY
(a) Install the clutch master cylinder assy and gasket with the 2 nuts.
Torque: 12 N m (120 kgf cm, 9 ft lbf)
RHD Steering Position Type:
LHD Steering Position Type:
MP Grease
SST(s)
12. INSTALL BRAKE BOOSTER ASSY (LHD STEERING POSITION TYPE)
13. INSTALL BRAKE MASTER CYLINDER SUB–ASSY (LHD STEERING POSITION TYPE)
(See page 32–13)
14. BLEED BRAKE LINE (LHD STEERING POSITION TYPE)
AVENSIS REPAIR MANUAL (RM1018E)
CLUTCH –
9. INSTALL CLUTCH MASTER CYLINDER PUSH ROD
CLEVIS W/HOLE PIN
(a) Apply MP grease to the contact surface of the hole pin
and clevis bush.
(b) Connect the clevis to the clutch pedal assy with the hole
pin.
HINT:
Y
RHD steering position type:
Install the hole pin from the right side of the vehicle.
Y
LHD steering position type:
Install the hole pin from the left side of the vehicle.
(c) Install the clip to the hole pin.
D30782
10. CONNECT CLUTCH MASTER CYLINDER TO
FLEXIBLE HOSE TUBE
(a) Using SST(s), connect the flexible hose tube.
SST
Torque: 15 N m (155 kgf cm, 11 ft lbf)
D30069
11. CONNECT CLUTCH RESERVOIR TUBE
(a) Connect the clutch reservoir tube with the clip to the clutch
master cylinder assy.
NOTICE:
Connect the clutch reservoir tube so as not be twisted.
Blue Mark
D30068
http://vnx.su
CLUTCH MASTER CYLINDER ASSY (MTM)
09023–00100
(See page 32–4)
(See page 32–19)