Toyota Avensis ZZT251 2003 Service And Repair Manual page 723

14–8
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL – VALVE CLEARANCE (1ZZ–FE/3ZZ–FE)
Turn the crankshaft 1 revolution (360 Y) and set No. 4 cyl-
(b)
inder to TDC/compression.
(c) Check the valves indicated in the illustration.
(1) Using a feeler gauge, measure the clearance be-
tween the valve lifter and camshaft.
(2) Record the out–of specification valve clearance
measurements. They will be used later to determine
the required replacement valve lifter.
Valve clearance (Cold):
Intake 0.15 to 0.25 mm (0.0059 to 0.0098 in.)
Exhaust 0.25 to 0.35 mm (0.0098 to 0.0138 in.)
A01132
12. REMOVE FAN AND GENERATOR V BELT
(a) Turn the V–ribbed belt tensioner clockwise slowly and
loosen it. Then, remove the fan and generator V belt and
put back the V–ribbed belt tensioner carefully.
A60622
13. REMOVE
SUB–ASSY RH
(a) Place a wooden block on a jack underneath the engine.
Remove the 4 bolts and 2 nuts and detach the engine
mounting insulator RH.
A01045
A64005
http://vnx.su
ENGINE MOUNTING INSULATOR