Toyota Avensis ZZT251 2003 Service And Repair Manual page 454

5
3 1
Bearing Cap No. 3
Bearing Cap No. 1
Bearing Cap No. 2 Bearing Cap No. 3
3 1
5
Tighten
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
15.
(a)
(b)
A77284
(c)
2 4
16.
(a)
A77415
(b)
A52473
(c)
2 4
A77416
(d)
Hold
NOTICE:
Be careful not to damage the cylinder head and valve lifter.
A77417
http://vnx.su
– CAMSHAFT (1AZ–FE)
INSTALL CAMSHAFT
Turn the crankshaft pulley, and align its groove with timing
mark 0 of the timing chain cover.
Install the timing chain on the camshaft timing gear, with
the painted links aligned with the timing marks on the
camshaft timing gear.
Examine the front marks and numbers and tighten the
bolts in the sequence shown in the illustration.
Torque:
Bearing cap No. 1 30 N m (301 kgf cm, 22 ft lbf)
Bearing cap No. 3 9.0 N m (92 kgf cm, 80 in. lbf)
INSTALL NO.2 CAMSHAFT
Put the No. 2 camshaft on the cylinder head with the
painted links of the chain aligned with the timing mark on
the camshaft timing gear.
Raising the No. 2 camshaft, tighten the set bolt temporari-
ly.
Examine the from marks and numbers and tighten the
bolts in the sequence shown in the illustration.
Torque:
Bearing cap No. 2 30 N m (301 kgf cm, 22 ft lbf)
Bearing cap No. 3 9.0 N m (92 kgf cm, 80 in. lbf)
Hold the camshaft with a wrench on the hexagonal lobe,
and tighten the camshaft timing gear set bolt.
Torque: 54 N m (551 kgf cm, 40 ft lbf)
14–175