Table of Contents
Advertisement
14–150
Seal Packing
49.
INSTALL CRANKSHAFT POSITION SENSOR
SST
Raise
Push
Hook
Pin
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
48.
INSTALL OIL PAN SUB–ASSY
NOTICE:
S
Remove any oil from the contact surface.
S
Install the oil pan within 3 minutes after applying seal
packing.
S
Do not start the engine within 2 hours after installing.
(a)
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surface of the cylinder
block and oil pan.
6mm
(b)
Apply a continuous bead (Diameter 3 mm to 4 mm (0.157
in.)) of seal packing as shown in the illustration, and install
the oil pan.
Seal packing: part No. 08826 – 00080 or equivalent
A77392
(c)
Install the oil pan with the 12 bolts and 2 nuts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
A64641
50.
INSTALL CRANKSHAFT PULLEY
(a)
Using SST, tighten the set bolt.
SST
Torque: 170 N m (1,733 kgf cm, 125 ft lbf)
A77393
51.
INSTALL CHAIN TENSIONER ASSY NO.1
(a)
Release the ratchet pawl, fully push in the plunger and ap-
ply the hook to the pin so that the plunger is located in
position.
A77394
http://vnx.su
–
CHAIN SUB–ASSY (1AZ–FE)
09213–54015 (91651–60855), 09330–00021
Advertisement
Table of Contents
