Toyota Avensis ZZT251 2003 Service And Repair Manual page 465

Disconnect
Pin
Hook
Plunger
Push
Turn
21. INSTALL CYLINDER HEAD COVER SUB–ASSY
22. INSTALL FUEL PUMP ASSY
23. INSTALL FUEL PIPE SUB–ASSY NO.1
SST 09023–12900
24. INSTALL FUEL TUBE SUB–ASSY
25. INSTALL FUEL PRESSURE PULSATION DAMPER ASSY
26. INSTALL IGNITION COIL ASSY
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
27. CHECK FOR ENGINE OIL LEAKS
28. INSTALL ENGINE COVER SUB–ASSY NO.1
Torque: 7.0 N m (71 kgf cm, 62 in. lbf)
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(b) Install a new gasket chain tensioner No. 1 with 2 nuts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
NOTICE:
If the hook is disengaged while installing, apply the hook
again, and then resume the installation.
Engine
Front
A77395
(c) Turn the crankshaft counterclockwise, and check that the
pin is disengaged from the hook.
Turn
A77396
(d) Turn the crankshaft clockwise, and check the plunger is
extended.
A77397
(See page 11–52)
(See page
(See page
http://vnx.su
– CAMSHAFT (1AZ–FSE)
(See page 14–222)
11–52)
11–30)
(See page
14–245
11–52)