Table of Contents
Advertisement
40.
INSTALL CYLINDER BLOCK WATER DRAIN COCK SUB–ASSY
(a)
Apply two or three threads of adhesive to the drain union, and install it within 3 minutes.
Torque: 20 N m (204 kgf cm15 ft lbf)
(b)
After applying the specified torque, rotate the drain union clockwise until its drain port faces downward.
NOTICE:
S
Do not put into coolant in an hour after the installation.
S
Do not rotate the drain union more than 360_ in (b), and never loosen it after setting the union
correctly.
41.
INSTALL OIL STRAINER SUB–ASSY
(a)
Install a new gasket and the oil strainer with the 2 nuts and a bolt.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
ENGINE MECHANICAL
–
PARTIAL ENGINE ASSY (1ZZ–FE/3ZZ–FE)
39.
INSPECT CAMSHAFT
(a)
Inspect camshaft for runout.
(1)
Place the camshaft on V–blocks.
(2)
Using a dial indicator, measure the circle runout at
the center journal.
Maximum circle runout: 0.03 mm (0.0012 in.)
EM1628
(b)
Inspect cam lobes.
(1)
Using a micrometer, measure the cam lobe height.
Standard cam lobe height:
Intake 44.333 – 44.433 mm (1.7454 – 1.7493 in.)
Exhaust 43.761 – 43.861 mm (1.7229 – 1.7268 in.)
Minimum cam lobe height:
Intake 44.18 mm (1.7394 in.)
Exhaust 43.61 mm (1.7169 in.)
EM2011
(c)
Inspect camshaft journals.
(1)
Using a micrometer, measure the journal diameter.
No. 1 journal diameter:
34.449 – 34.465 mm (1.3563 – 1.3569 in.)
Others journal diameter:
22.949 – 22.965 mm (0.9035 – 0.9041 in.)
If the journal diameter is not as specified, check the oil clear-
ance.
EM2538
http://vnx.su
14–13
Advertisement
Table of Contents
