Toyota Avensis ZZT251 2003 Service And Repair Manual page 1217

42–28
7
SST(s)
3
6
Matchmarks
2.5
SST(s)
AVENSIS REPAIR MANUAL (RM1018E)
CLUTCH
12.
(a)
HINT:
The bearing is permanently lubricated and requires no cleaning
or lubrication.
Replace the release bearing assy as necessary.
13.
(a)
Q01060
NOTICE:
Take care not to insert the clutch disc assy in the wrong
direction.
1CD–FTV Engine Type:
Flywheel Side
SST(s)
14.
1 (Temporally), 4
(a)
(b)
8
HINT:
Y
D26323
Y
15.
(a)
If the alignment is not as specified, adjust the diaphragm spring
tip alignment using SST(s).
D00205
http://vnx.su
– CLUTCH UNIT (MTM)
INSPECT CLUTCH RELEASE BEARING ASSY
Turn the release bearing by hand while applying force in
the axial direction.
INSTALL CLUTCH DISC ASSY
Insert SST(s) in the clutch disc assy, then insert them in
the flywheel sub–assy.
SST 09301–00220
Others:
INSTALL CLUTCH COVER ASSY
Align matchmarks on the clutch cover assy and flywheel
sub–assy.
Following the procedures shown in the illustration, tighten
the 6 bolts, in the order starting from the bolt located near
the knock pin on the top.
Torque: 19 N m (195 kgf cm, 14 ft lbf)
Following the order in the illustration, tighten the bolts at
a time evenly.
Move SST(s) up and down, right and left lightly, after
checking that the disc is in the center, and then tighten the
bolts.
INSPECT AND ADJUST CLUTCH COVER ASSY
Using a dial indicator with roller instrument, check the dia-
phragm spring tip alignment.
Maximum non–alignment: 0.5 mm (0.020 in.)
SST 09333–00013
D30059