Toyota Avensis ZZT251 2003 Service And Repair Manual page 476

14–324
SST
54. INSTALL INJECTION PIPE SUB–ASSY NO.2
SST 09023–12700
HINT:
Perform the same procedures as injection pipe No. 1.
55. INSTALL INJECTION PIPE SUB–ASSY NO.3
SST 09023–12700
HINT:
Perform the same procedures as injection pipe No. 1.
56. INSTALL INJECTION PIPE SUB–ASSY NO.4
SST 09023–12700
HINT:
Perform the same procedures as injection pipe No. 1.
57. INSTALL TIMING BELT
58. CHECK VALVE TIMING
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL –
(c) Using SST, tighten the nut of the injection pipe to the com-
Fulcrum
mon rail side.
Length
SST
30 cm
Torque:
42 N m (428 kgf cm, 31 ft lbf) for a used pipe using SST
46 N m (469 kgf cm, 34 ft lbf) for a used pipe not using
SST
31 N m (316 kgf cm, 23 ft lbf) for a new pipe using SST
34 N m (347 kgf cm, 25 ft lbf) for a new pipe not using
A79147
SST
HINT:
S
Use a torque wrench with a fulcrum length of 30 cm
(11.81 in.)
S
Check if the used pipe has deflection or is installed prop-
erly after injection pipe is reassembled. If there is deflec-
tion or if it can not be installed properly, replace the used
pipe with a new pipe.
(d) Using SST, tighten the nut of the injection pipe to the injec-
tor side.
SST
Torque:
42 N m (428 kgf cm, 31 ft lbf) for a used pipe using SST
46 N m (469 kgf cm, 34 ft lbf) for a used pipe not using
SST
31 N m (316 kgf cm, 23 ft lbf) for a new pipe using SST
34 N m (347 kgf cm, 25 ft lbf) for a new pipe not using
SST
HINT:
S
Use a torque wrench with a fulcrum length of 30 cm
(11.81 in.)
S
Check if the used pipe has deflection or is installed prop-
erly after injection pipe is reassembled. If there is deflec-
tion or if it can not be installed properly, replace the used
pipe with a new pipe.
(e) Install the 2 upper injection pipe clamps with the 2 nuts.
Torque: 5.0 N m (51 kgf cm, 44 in. lbf)
(See page 14–307)
(See page 14–307)
http://vnx.su
CAMSHAFT (1CD–FTV)
09023–12700
09023–12700