Toyota Avensis ZZT251 2003 Service And Repair Manual page 799

14–26
Plunger
Push
Seal Packing
67. INSTALL SPARK PLUG
(a) Using a spark lug wrench, install the 4 spark plugs.
Torque: 25 N m (255 kgf cm, 18 ft lbf)
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
ENGINE MECHANICAL
Turn
A62181
HINT:
If the plunger does not spring out, press the slipper into the
chain tensioner with a screwdriver or your finger so that the
hook is released from the knock pin and the plunger springs out.
A10085
66.
(a)
(b)
(c)
NOTICE:
S
A62182
S
S
(d)
http://vnx.su
– PARTIAL ENGINE ASSY (1ZZ–FE/3ZZ–FE)
(4) Turn the crankshaft clockwise, and check that the
slipper is pushed by the plunger.
INSTALL CYLINDER HEAD COVER SUB–ASSY
Install the gasket to the cylinder head cover.
Remove any old packing (FIPG) material.
Apply seal packing to 2 locations as shown in the illustra-
tion.
Seal packing: Part No. 08826–00080 or equivalent
Remove any oil from the contact surface.
Install the cylinder head cover within 3 minutes after
applying seal packing.
Do not put into engine oil 2 hours after installing.
Install the cylinder head cover and cable bracket with the
9 bolts, 2 seal washers and 2 nuts
Uniformly tighten the bolts and nuts, in the several
passes.
Torque:
w/o washer 11 N m (112 kgf cm, 8 ft lbf)
w/ washer 9.0 N m (92 kgf cm, 80 in lbf)