Toyota Avensis ZZT251 2003 Service And Repair Manual page 711

Pry
SST
13. INSTALL FRONT WHEEL RH
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
14. CHECK FOR ENGINE OIL LEAKS
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
9. REMOVE TIMING GEAR COVER OIL SEAL
(a) Using a knife, cut off the oil seal lip.
Cut Position
(b) Using a screwdriver with the tip wrapped in tape, pry out
the oil seal.
NOTICE:
After the removal, check if the crankshaft is not damaged.
If it is damaged, smooth the surface with 400–grit sandpa-
per.
A62183
10. INSTALL TIMING GEAR COVER OIL SEAL
SST (a) Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip free of foreign objects.
(b) Using SST, tap in the oil seal until its surface is flush with
the timing chain cover edge.
SST
NOTICE:
Wipe off extra grease on the crankshaft.
A62184
11. INSTALL CRANKSHAFT PULLEY
(a) Align the keyway of the pulley with the key located on the
crankshaft and slide the pulley into place.
(b) Using SST, install the crankshaft pulley bolt.
SST
Torque: 138 N m (1,407 kgf cm, 102 ft lbf)
A62837
12. INSTALL
SUB–ASSY RH
(a) Install the engine mounting insulator with the 4 bolts and
2 nuts.
Torque: 52 N m (530 kgf cm, 38 ft lbf)
A64005
http://vnx.su
– TIMING CHAIN OR BELT COVER OIL
SEAL (1ZZ–FE/3ZZ–FE)
09223–22010
09960–10010 (09962–01000, 09963–01000)
ENGINE MOUNTING INSULATOR
14–97