Toyota Avensis ZZT251 2003 Service And Repair Manual page 760

Upper Side Rail Compression No. 2
Front
Compression No. 1
or Expander
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
ENGINE MECHANICAL
34.
Cord Mark
HINT:
In case of reusing the piston rings, install them to the matched
pistons with the surfaces faced correctly.
(a)
(b)
A62811
(c)
Lower Side Rail
A62812
35.
(a)
NOTICE:
Clean the backside of the bearing and the bearing surface
of the connecting rod and let not stick the oils and fats.
A01188
36.
(a)
NOTICE:
Clean the backside of the bearing and the bearing surface
of the bearing cap and let not stick the oils and fats.
A01190
(b)
NOTICE:
Clean the backside of the bearing and the bearing surface
of the bearing cap and let not stick the oils and fats.
A01189
http://vnx.su
– CYLINDER BLOCK (1ZZ–FE/3ZZ–FE)
INSTALL PISTON RING SET
Install the oil ring expander and 2 side rails by hand.
Using a piston ring expander, install the 2 compression
rings with the code mark facing upward.
Code mark (No.2 only): T or 2R
Position the piston rings so that the ring ends are as
shown.
INSTALL CONNECTING ROD BEARING
Align the bearing claw with the groove of the connecting
rod or connecting cap.
INSTALL CRANKSHAFT
Install the upper bearing with an oil groove on cylinder
block.
Install the lower bearing on the bearing cap sub–assy.
14–51