Toyota Avensis ZZT251 2003 Service And Repair Manual page 1038

C(-54)
18. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
19. CHECK ABS SPEED SENSOR SIGNAL
(a) ABD WITH EBD SYSTEM
(b) ABD WITH EBD & BA & TRC & VSC SYSTEM (
AVENSIS REPAIR MANUAL (RM1018E)
REAR SUSPENSION – REAR SUSPENSION ARM ASSY NO.1 LH
(f) Fully tighten the bolt and nut.
Torque: 74 N m (755 kgf cm, 55 ft lbf)
NOTICE:
When installing the bolt, hold the nut not to rotate.
G23881
17. FULLY TIGHTEN LOWER CONTROL ARM ASSY LH
NOTICE:
Be sure to empty the vehicle when fully tightening the bolt
and nut.
(a) Fully tighten the nut.
Torque: 60 N m (612 kgf cm, 44 ft lbf)
(b) Install the clip.
NOTICE:
Y
When the holes for the clip are not aligned, adjust
G25777
them by tightening the nut. The tightening angle for
the adjustment must be less than 60_.
Y
Insert the clip from the rear side of a vehicle.
(c) Fully tighten the bolt.
Torque: 105 N m (1,071 kgf cm, 77 ft lbf)
G23871
(See page 05–699)
See page
http://vnx.su
(See page 27–4)
05–756)
27–23