Toyota Avensis ZZT251 2003 Service And Repair Manual page 972

GENERATOR ASSY (1CD–FTV)
REPLACEMENT
1. REMOVE FRONT WHEEL RH
2. REMOVE RADIATOR SUPPORT OPENING COVER
3. REMOVE ENGINE ROOM COVER SIDE
4. REMOVE ENGINE UNDER COVER SUB–ASSY NO.1
5. REMOVE ENGINE UNDER COVER RH
6. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 14–269)
7. REMOVE GENERATOR V BELT
8. REMOVE FLOOR PANEL BRACE FRONT
9. REMOVE EXHAUST PIPE ASSY FRONT
10. REMOVE EXHAUST PIPE ASSY (W/ COLD AREA)
12. INSTALL GENERATOR ASSY
Torque:
31 N m (320 kgf cm, 23 ft lbf) for M8
47 N m (475 kgf cm, 34 ft lbf) for M10
9.8 N m (100 kgf cm, 7 ft lbf) for Generator wire
5.0 N m (51 kgf cm, 44 ft lbf) for Wire harness
13. INSTALL EXHAUST PIPE ASSY (W/ COLD AREA)
14. INSTALL EXHAUST PIPE ASSY FRONT
15. INSTALL FLOOR PANEL BRACE FRONT
16. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 14–286)
17. INSTALL FRONT WHEEL RH
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
18. CHECK FOR EXHAUST GAS LEAKS
AVENSIS REPAIR MANUAL (RM1018E)
STARTING & CHARGING –
(See page 14–269)
(See page
(See page
11. REMOVE GENERATOR ASSY
(a) Remove the bolt and disconnect the wire harness.
(b) Remove the cap and nut, disconnect the generator wire.
(c) Disconnect the generator connector.
(d) Remove the 2 bolts and the generator.
A79176
(See page
(See page
http://vnx.su
GENERATOR ASSY (1CD–FTV)
15–10)
15–10)
(See page 13–11)
(See page 13–11)
15–10)
15–10)
19–29
190O1–01