Toyota Avensis ZZT251 2003 Service And Repair Manual page 697

SST
5
3
8
90_
SST
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(b)
A76713
113. INSTALL FLYWHEEL SUB–ASSY (M/T TRANSAXLE)
(a)
A62838
(b)
(c)
1
7
(d)
4
6
2
A62205
(e)
(f)
(g)
A62206
114. INSTALL DRIVE PLATE & RING GEAR SUB–ASSY
(a)
A62838
http://vnx.su
– PARTIAL ENGINE ASSY (1ZZ–FE/3ZZ–FE)
Install the engine wire with the 2 nuts.
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
Hold the crankshaft with SST.
SST 09960–10010 (09962–01000, 09963–01000)
Clean the bolt and bolt hole.
Apply adhesive to the bolts.
Adhesive:
Part No. 09330–00070, THREE BOND or equivalent.
Using several steps, install and tighten the 8 bolts uni-
formly in the sequence shown in the illustration.
Torque: 49 N m (500 kgf cm, 36 ft lbf)
Mark each bolt head with paint.
Retighten the bolts by an additional 90_ in the same se-
quence as step (d).
Check that the paint marks are at 90_ angle about the
original position.
(A/T TRANSAXLE)
Hold the crankshaft with SST.
SST 09960–10010 (09962–01000, 09963–01000)
14–41