Table of Contents
Advertisement
14.
REMOVE NOZZLE HOLDER CLAMP
(a)
Remove the 4 bolts, 4 washers and 4 nozzle holder clamps.
15.
REMOVE INJECTOR ASSY
(a)
Remove the 4 injectors from the cylinder head.
(b)
Remove the O–rings and back–up rings from each injector.
(c)
Remove the 4 nozzle seats from the cylinder head.
16.
REGISTRATION OF INJECTOR COMPENSATION CODE
HINT:
Each injector assembly has a characteristic fuel injecting behavior. When replacing the injector assembly,
store them in correct order so that they can be returned to the original locations when re–assembling.
AVENSIS REPAIR MANUAL (RM1018E)
FUEL
–
INJECTOR ASSY (1CD–FTV)
11.
REMOVE NOZZLE HOLDER SEAL
(a)
Using a screwdriver, pry out the 4 nozzle holder seals.
A09656
12.
REMOVE CYLINDER HEAD COVER SUB–ASSY
(a)
Remove the 10 bolts and the cylinder head cover.
A79144
13.
REMOVE NOZZLE LEAKAGE PIPE ASSY
(a)
Remove the union bolt and the 4 hollow screws, then re-
move the nozzle leakage pipe and the 5 gaskets.
NOTICE:
When removing then nozzle leakage pipe, place the shop
rag under the pipe to protect the cylinder head from the fuel
remaining inside the pipe.
A80110
17.
INSTALL INJECTOR ASSY
(a)
Install 4 new nozzle seats to the cylinder head.
http://vnx.su
(See page
05–528)
11–61
Advertisement
Table of Contents
