Toyota Avensis ZZT251 2003 Service And Repair Manual page 305

10–16
30Y to 45Y
Rotation
Center of
Throttle Link
66.3 mm
11Y
(2.610 in.)
14. INSTALL AIR CLEANER CAP SUB–ASSY
15. INSTALL CYLINDER HEAD COVER NO.2
16. ADD ENGINE COOLANT
17. CHECK FOR ENGINE COOLANT LEAKS
18. INSTALL ENGINE ROOM COVER SIDE
19. INSTALL RADIATOR SUPPORT OPENING COVER
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE CONTROL SYSTEM
9. REMOVE THROTTLE POSITION SENSOR
(a) Remove the 2 screws, and then remove the throttle posi-
tion sensor.
A78501
10. INSTALL THROTTLE POSITION SENSOR
(a) Make sure that the throttle valve is fully closed.
(b) With the throttle position sensor rotated 30Y to 45Y coun-
terclockwise about the fully closed position of the throttle
valve, install the throttle position sensor to the throttle
body.
(c) Rotate the throttle position sensor clockwise and secure
it with the 2 screws.
Torque: 2.0 N m (20 kgf cm, 18 in. lbf)
A78503
11. INSTALL ISC VALVE
(a) Install a new gasket to the throttle body.
(b) Install the ISC valve with the 4 screws.
Torque: 3.7 N m (38 kgf cm, 33 in. lbf)
12. INSTALL THROTTLE BODY ASSY
(a) Install a new gasket to the intake manifold.
(b) Install the throttle body and the accelerator control brack-
et with the bolt and 2 nuts.
Torque: 30 N m (306 kgf cm, 22 ft lbf)
13. INSTALL ACCELERATOR CONTROL CABLE ASSY
(a) Install the accelerator control cable as shown in the il-
lustration.
Torque: 13 N m (129 kgf cm, 9 ft lbf)
A78469
(See page
(See page
(See page 16–7)
(See page
http://vnx.su
– THROTTLE BODY ASSY (3ZZ–FE)
10–9)
10–9)
16–1)