Toyota Avensis ZZT251 2003 Service And Repair Manual page 1264

SST(s)
Fulcrum
Length
Turn
36. INSTALL STEERING RACK BOOT NO.1
HINT:
Perform the same procedure on the other side.
3 mm (0.12 in.) or less
38. INSTALL STEERING RACK BOOT NO.1 CLAMP
SST 09521–24010
HINT:
Perform the same procedure on the other side.
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
34.
(a)
SST(s)
NOTICE:
Use SST(s) 09922–10010 in the direction shown in the il-
lustration.
Hold
HINT:
F40053
Y
Y
35.
(a)
(b)
NOTICE:
Be careful not to damage or twist the boot.
C57755
37.
SST(s)
(a)
(b)
F40084
http://vnx.su
– STEERING GEAR ASSY
INSTALL STEERING RACK END SUB–ASSY
Using SST(s), hold the steering rack steadily and using
another SST(s), torque the rack end sub–assy.
SST 09922–10010
Torque: 60 N m (616 kgf cm, 45 ft lbf)
Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.)
Perform the same procedure on the other side.
INSTALL STEERING RACK BOOT NO.2
Apply silicon grease to the inside small caliber of rack
boot No.2.
Install the rack boot No.2 to the groove on the rack hous-
ing.
INSTALL STEERING RACK BOOT NO.2 CLAMP
Install a new rack boot No.2 clamp to the rack boot No.2.
Using SST(s), stake the rack boot No.2 clamp as shown
in the illustration.
SST 09521–24010
51–31