Table of Contents
Advertisement
SST
Seal Width
New Gasket
2 to 4 mm
Seal
Packing
AVENSIS REPAIR MANUAL (RM1018E)
LUBRICATION
–
OIL PUMP ASSY (1CD–FTV)
35.
INSTALL CRANKSHAFT SEAL
(a)
Using SST and a hammer, tap in a new oil seal until its sur-
face is flush with the oil pump edge.
SST
09316–60011 (09316–00011, 09316–00021)
A56700
36.
INSTALL OIL PUMP ASSY
(a)
Remove any old packing (FIPG) and be careful not to
drop any oil on the contact surfaces of the oil pump and
the cylinder block.
(1)
Using a razor blade and a gasket scraper, remove
all the old packing from the gasket surfaces and the
sealing groove.
(2)
Thoroughly clean all components to remove all the
loose material.
(3)
Using a non–residue solvent, clean both the sealing
surfaces.
(b)
Apply seal packing to the oil pump as shown in the illustra-
tion.
Seal packing: Part No. 08826–00080 or equivalent
NOTICE:
Avoid applying an excessive amount to the surface.
(1)
Install a nozzle that has been cut to a 2 to 4 mm
(0.08 to 0.16 in.) opening.
(2)
Parts must be set within 3 minutes and assembled
within 15 minutes of application. Otherwise the ma-
B07987
terial must be removed and reapplied.
(3)
Immediately remove nozzle from the tube and rein-
stall the cap.
(c)
Install a new gasket to the oil pump.
(d)
Pour in 0.5 cm
bushing of the cylinder block.
(e)
Apply engine oil to the cylinder block side where it con-
tacts with the oil pump driven rotor.
B08024
http://vnx.su
3
(0.03 cu in.) or more of engine oil into the
17–25
Advertisement
Table of Contents
