Table of Contents
Advertisement
Grease
13.
INSTALL STARTER ARMATURE ASSY
(a)
Install the starter armature to the starter yoke.
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
STARTING & CHARGING
(f)
(g)
ST0741
(h)
Cutout
Protrusion
A62228
14.
(a)
(b)
(c)
A30137
(d)
NOTICE:
To avoid interference between the brush holder and the
dust protector push the commutator and frame away at an
angle.
ST0728
http://vnx.su
–
STARTER ASSY (1ZZ–FE/3ZZ–FE)
Apply grease to the drive lever touching the starter pivot
part of the drive lever.
Install the drive lever to the starter clutch.
Align the protrusion of the shock absorber with the cutout
of the starter housing and install them.
INSTALL STARTER BRUSH HOLDER ASSY
Install the brush holder.
Using a screwdriver, hold the brush spring back, and con-
nect the brush into the brush holder.
Connect the 4 brushes.
Apply turbine oil with additives to the bearing of the end
frame.
Install the end frame with 2 new screws.
Torque: 1.5 N m (15 kgf cm, 13 in. lbf)
19–7
Advertisement
Table of Contents
