Toyota Avensis ZZT251 2003 Service And Repair Manual page 1259

50. INSTALL HEIGHT CONTROL SENSOR SUB–ASSY FR RH (W/ DISCHARGE HEAD LAMP)
(See page 65–28)
51. INSTALL TIE ROD END SUB–ASSY LH
52. INSTALL TIE ROD END SUB–ASSY RH
HINT:
Perform the same procedure on the other side.
53. INSTALL FRONT WHEELS
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
54. INSTALL STEERING COLUMN HOLE COVER SUB–ASSY NO.1
RHD:
A
B
LHD:
A
C(()EF
C(()F-
56. INSTALL COLUMN HOLE COVER SILENCER SHEET
57. INSTALL CYLINDER HEAD COVER SUB–ASSY
58. ADD POWER STEERING FLUID
59. BLEED POWER STEERING FLUID
60. CHECK POWER STEERING FULUID LEVEL IN RESERVER
61. INSPECT FLUID LEAK
62. INSPECT HOOD SUB–ASSY
63. ADJUST HOOD SUB–ASSY
64. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
65. INSTALL ENGINE UNDER COVER LH
66. INSTALL ENGINE UNDER COVER RH
67. HEADLIGHT AIM ONLY (W/ DISCHARGE HEAD LAMP)
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
55.
(a)
(b)
Matchmarks
B
Matchmarks
D30705
(See page
(See page
(See page
(See page
http://vnx.su
– RACK & PINION POWER STEERING GEAR ASSY
(See page 30–6)
INSTALL STEERING INTERMEDIATE SHAFT ASSY
NO.2
Align the matchmarks on the intermediate shaft assy No.2
and the intermediate shaft.
Install the bolt B and tighten the bolt A.
Torque: 35 N m (360 kgf cm, 26 ft lbf)
(See page
51–4)
51–4)
(See page
75–2)
75–2)
(See page
(See page
50–9)
51–4)
26–6)
65–19)
51–45