Toyota Avensis ZZT251 2003 Service And Repair Manual page 1218

16. INSTALL RELEASE FORK SUPPORT
(a) Install the release fork support to the transaxle assy.
Torque:
1ZZ–FE/3ZZ–FE/1CD–FTV Engine Type: 37 N m (375 kgf cm, 27 ft lbf)
1AZ–FSE/1AZ–FE Engine Type: 47 N m (480 kgf cm, 35 ft lbf)
17. INSTALL RELEASE BEARING HUB CLIP
EXCEPT 1CD–FTV Engine Type:
1CD–FTV Engine Type:
Release Hub Grease
19. INSTALL CLUTCH RELEASE BEARING ASSY
(a) Apply the clutch spline grease to the input shaft spline.
Sealant:
Part No. 08887–01706, CLUTCH SPLINE GREASE or equivalent
(b) Install the bearing to the release fork, and then install them to the transaxle assy.
NOTICE:
After the installation, move the folk forward and backward to check that the release bearing slides
smoothly.
20. INSTALL CLUTCH RELEASE FORK BOOT
21. INSTALL MANUAL TRANSAXLE ASSY
(a) 1ZZ–FE, 3ZZ–FE Engine
(b) 1AZ–FE, 1AZ–FSE Engine
(c) 1CD–FTV Engine
AVENSIS REPAIR MANUAL (RM1018E)
CLUTCH
18.
(a)
(b)
D26819
(See page 41–15)
(See page 41–24)
(See page 41–33)
http://vnx.su
– CLUTCH UNIT (MTM)
INSTALL CLUTCH RELEASE FORK SUB–ASSY
Apply the release hub grease to the release fork and re-
lease bearing assy contact, release fork and push rod
contact, and release fork pivot points.
Sealant:
Part No. 08887–01806, RELEASE HUB GREASE or
equivalent
Install the release fork to the release bearing assy.
42–29