Toyota Avensis ZZT251 2003 Service And Repair Manual page 1275

51–26
F(-(E)
29. INSTALL POWER STEERING SUCTION PORT UNION
(a) Coat a new O–ring with power steering fluid, and install it to the suction port union.
(b) Install the suction port union with the bolt.
Torque: 12 N m (122 kgf cm, 9 ft lbf)
A
SST(s)
32. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Connect the oil reservoir to pump hose No. 1 with the clip.
NOTICE:
Take care not to spill fluid on the V belt.
33. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 55–46)
34. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
(See page 55–46)
35. ADD POWER STEERING FLUID
36. BLEED POWER STEERING FLUID
37. CHECK POWER STEERING FULUID LEVEL IN RESERVER
38. INSPECT FLUID LEAK
AVENSIS REPAIR MANUAL (RM1018E)
POWER STEERING
28.
(a)
(b)
(c)
(d)
D30361
30.
(a)
B
B
B
D30580
31.
(a)
Fulcrum
Length
HINT:
Y
Y
D30581
(b)
(See page
(See page
http://vnx.su
– VANE PUMP ASSY (1CD–FTV)
INSTALL FLOW CONTROL VALVE ASSY
Coat the compression spring and the flow control valve
assy with power steering fluid.
Install the compression spring and the flow control valve
assy.
Coat a new O–ring with power steering fluid and install it
onto the pressure port union sub–assy.
Install the pressure port union sub–assy.
Torque: 69 N m (704 kgf cm, 51 ft lbf)
INSTALL VANE PUMP ASSY
Install the vane pump assy and vane pump bracket rear
with the 4 bolts.
Torque:
Bolt A: 72 N m (734 kgf cm, 53 ft lbf)
Bolt B: 39 N m (398 kgf cm, 29 ft lbf)
CONNECT PRESSURE FEED TUBE ASSY
Using SST(s), connect the pressure feed tube assy.
SST 09023–12700
Torque: 41 N m (414 kgf cm, 30 ft lbf)
Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.).
This torque value is effective when SST(s) is parallel to a
torque wrench.
Install the tube clamp with the bolt.
Torque: 8.0 N m (82 kgf cm, 71 in. lbf)
51–4)
51–4)
(See page 51–4)