Table of Contents
Advertisement
4.
REMOVE CONNECTING ROD BEARING
(a)
Remove the connecting rod bearing from the connecting rod and crankshaft.
SST
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
ENGINE MECHANICAL
–
CYLINDER BLOCK (1ZZ–FE/3ZZ–FE)
5.
REMOVE PISTON RING SET
HINT:
Take care not to misplace the piston rings on both the match
with the piston and the direction of the rings.
(a)
Using a piston ring expander, remove the 2 compression
rings.
(b)
Remove the 2 side rails and oil ring by hand.
A01175
6.
REMOVE PISTON PIN HOLE SNAP RING
(a)
Using a small screwdriver, pry out the 2 snap rings.
A01192
7.
REMOVE W/PIN PISTON SUB–ASSY
(a)
Gradually heat the piston to 80 – 90_C (176 – 194_F).
(b)
Using a plastic hammer and brass bar, lightly tap out the
piston pin and remove the connecting rod.
HINT:
Y
The piston and pin are a matched set.
Y
Arrange the piston, pins, ring, connecting rod and bear-
ings in the correct order.
A01179
8.
REMOVE CONNECTING ROD SMALL END BUSH
(a)
Using SST and a press, press out the bushing.
SST
A62800
http://vnx.su
09222–30010
14–41
Advertisement
Table of Contents
