Table of Contents
Advertisement
DRIVE SHAFT / PROPELLER SHAFT
AVENSIS REPAIR MANUAL (RM1018E)
–
REAR AXLE CARRIER SUB–ASSY LH
15.
INSPECT REAR AXLE CARRIER SUB–ASSY LH
(a)
As shown in the illustration, flip the ball joint stud back and
forth 5 times, before installing the nut.
(b)
Using a torque wrench, turn the nut continuously at a rate
of 3 – 5 seconds per turn and take the torque reading on
the 5th turn.
Turning torque (Maximum):
3.0 N m (30 kgf cm, 27 in. lbf)
NOTICE:
G21613
Y
Neither abnormal drag nor rattle exists during the
rotation.
Y
Neither crack nor grease leakage exists and deforma-
tion on the dust cover.
16.
INSTALL REAR AXLE CARRIER SUB–ASSY LH
(a)
Install the hub & bearing assy and rear axle carrier sub–
assy with the 4 bolts and nut.
Torque:
Bolt: 56 N m (571 kgf cm, 41 ft lbf)
Nut: 140 N m (1,428 kgf cm, 103 ft lbf)
G20965
17.
TEMPORARILY TIGHTEN UPPER CONTROL ARM
ASSY
(a)
Temporarily tighten the upper control arm assy with the
bolt and nut.
Temporarily tighten torque:
7 – 13 N m (71 – 133 kgf cm, 5.1 – 9.6 ft lbf)
HINT:
Insert the bolt from the rear side of the vehicle and temporarily
install the bolt.
G21542
18.
TEMPORARILY TIGHTEN REAR SUSPENSION ARM
ASSY NO.1 LH
(a)
Temporarily tighten the rear suspension arm assy (ball
joint side) with the nut.
(b)
Temporarily tighten the bolt and nut.
Temporarily tighten torque:
7 – 13 N m (71 – 133 kgf cm, 5.1 – 9.6 ft lbf)
HINT:
Insert the bolt from the rear side of the vehicle and temporarily
G21537
install the bolt.
http://vnx.su
30–33
Advertisement
Table of Contents
