32–10
8.
INSTALL BRAKE PEDAL SUB–ASSY
(a)
Apply lithium soap base glycol grease to the inside surface of 2 new bushes.
(b)
Install the brake pedal sub–assy and 2 bushes to the brake pedal support sub–assy with the brake
pedal shaft and nut.
Torque: 37 N m (375 kgf cm, 27 ft lbf)
10.
INSTALL COMBINATION METER ASSEMBLY
11.
CHECK AND ADJUST BRAKE PEDAL HEIGHT
12.
CHECK PEDAL FREE PLAY
13.
CHECK PEDAL RESERVE DISTANCE
AVENSIS REPAIR MANUAL (RM1018E)
BRAKE
–
BRAKE PEDAL SUB–ASSY
9.
INSTALL BRAKE PEDAL SUPPORT SUB–ASSY
(a)
Install the brake pedal support sub–assy with the 4 nuts.
Torque: 13 N m (130 kgf cm, 9 ft lbf)
(b)
Connect the stop lamp switch connector to the stop lamp
switch assy.
(c)
Apply lithium soap base glycol grease to the clevis pin.
(d)
Install the clip and clevis pin, and connect the brake mas-
ter cylinder push rod clevis with the clevis pin and clip.
G23175
(e)
Install the bolt to the brake pedal support assy.
Torque: 24 N m (241 kgf cm, 17 ft lbf)
G23220
(See page
(See page
(See page
32–6)
(See page
32–6)
http://vnx.su
71–21)
32–6)