Table of Contents
Advertisement
56.
REMOVE IDLER PULLEY SUB–ASSY
57.
REMOVE TIMING BELT NO.2 COVER
58.
REMOVE TIMING BELT NO.1 COVER
59.
REMOVE TIMING BELT GUIDE
60.
REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET
61.
SET NO. 1 CYLINDER TO TDC/COMPRESSION
62.
REMOVE TIMING BELT
HINT:
If re–use the timing belt, draw an arrow which indicates the engine revolution direction on the belt and put
match marks on the pulleys and the belt before removing. This operation will be very helpful when re–instal-
ling the timing belt.
63.
REMOVE GENERATOR ASSY
64.
REMOVE GENERATOR BRACKET NO.1
(a)
Remove the 2 bolts and the generator bracket.
65.
REMOVE V–RIBBED BELT TENSIONER ASSY
67.
REMOVE TURBO INSULATOR NO.2
68.
REMOVE TURBO INSULATOR NO.1
69.
REMOVE EXHAUST MANIFOLD HEAT INSULATOR NO.2
70.
REMOVE MANIFOLD STAY NO.2
71.
REMOVE MANIFOLD STAY
72.
REMOVE EXHAUST MANIFOLD CONVERTER SUB–ASSY
73.
REMOVE TURBOCHARGER STAY
74.
DISCONNECT TURBO WATER HOSE NO.1
75.
DISCONNECT TURBO WATER HOSE NO.2
76.
SEPARATE TURBO OIL INLET PIPE SUB–ASSY
77.
REMOVE TURBO OIL OUTLET PIPE NO.2
78.
REMOVE TURBOCHARGER SUB–ASSY
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
–
(See page
(See page
(See page
(See page
14–307)
66.
REMOVE OIL FILTER BRACKET SUB–ASSY
(a)
Remove the bolt and 2 nuts, and then remove the oil filter
bracket and the gasket.
A15985
(See page
(See page
(See page
13–11)
(See page
13–11)
(See page
13–11)
(See page
(See page
(See page
(See page
79.
DISCONNECT WATER BY–PASS HOSE NO.3
A78280
http://vnx.su
PARTIAL ENGINE ASSY (1CD–FTV)
14–307)
14–307)
14–307)
(See page
(See page
14–307)
13–11)
13–11)
(See page
13–11)
(See page
13–11)
13–11)
(See page
13–11)
13–11)
13–11)
14–291
14–307)
13–11)
Advertisement
Table of Contents
