Toyota Avensis ZZT251 2003 Service And Repair Manual page 618

SST
5
3
8
90 Y
SST
5
3
8
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
9.
(a)
A62838
(b)
(c)
1
7
(d)
4
6
2
A62205
(e)
(f)
(g)
10.
11.
A62206
12.
(a)
A62838
(b)
(c)
1
7
(d)
4
(e)
6
2
A62204
http://vnx.su
– ENGINE REAR OIL SEAL (1ZZ–FE/3ZZ–FE)
INSTALL FLYWHEEL SUB–ASSY (M/T TRANSAXLE)
Fix the crankshaft with SST.
SST 09960–10010 (09962–01000, 09963–01000)
Clean the bolt and bolt hole.
Apply adhesive to the bolts.
Adhesive:
Part No. 09330–00070, THREE BOND or equivalent.
Using several steps, Install and tighten the 8 bolts uni-
formly in the sequence shown in the illustration.
Torque: 49 N m (500 kgf cm, 36 ft lbf)
Mark the bolts with paint as shown in the illustration.
Retighten the bolts by an additional 90Y in the same se-
quence as step (d).
Check that the paint marks of each bolt are at 90Y angle
from the original position.
INSTALL CLUTCH DISC ASSY (M/T TRANSAXLE)
(See page 42–26)
INSTALL CLUTCH COVER ASSY (M/T TRANSAXLE)
(See page 42–26)
INSTALL DRIVE PLATE & RING GEAR SUB–ASSY
(A/T TRANSAXLE)
Fix the crankshaft with SST.
SST 09960–10010 (09962–01000, 09963–01000)
Clean the bolt and bolt hole.
Apply adhesive to the bolts.
Adhesive:
Part No. 09330–00070, THREE BOND or equivalent.
Using several steps, install and tighten the 8 bolts uni-
formly in the sequence shown in the illustration.
Fix the crankshaft with SST.
Torque: 88 N m (897 kgf cm, 65 ft lbf)
14–99