Toyota Avensis ZZT251 2003 Service And Repair Manual page 1121

32–62
SST
8. INSTALL REAR AXLE HUB & BEARING ASSY LH
9. INSTALL REAR BRAKE DRUM SUB–ASSY
(a) Aligning the matchmarks, install the rear disc.
10. INSTALL REAR DISC BRAKE CALIPER ASSY LH
(a) Install the rear disc brake caliper assy LH with the 2 bolts.
Torque: 47 N m (475 kgf cm, 34 ft lbf)
12. INSTALL REAR WHEEL
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
14. CHECK ABS SPEED SENSOR SIGNAL
AVENSIS REPAIR MANUAL (RM1018E)
BRAKE – SKID CONTROL SENSOR
7. INSTALL SKID CONTROL SENSOR
(a) Clean the contacting surface of the axle hub and that of
a new skid control sensor.
NOTICE:
Make sure the sensor rotor is clean.
(b) Place the skid control sensor on the axle hub so that the
connector comes into the most downward position under
the on vehicle condition.
G23168
(c) Using SST and a press, install the skid control sensor to
the axle hub.
NOTICE:
Y
Do not tap the skid control sensor directly with a ham-
mer.
Y
Check that there is no foreign matter on the skid con-
trol sensor detection portion.
Y
Press in the skid control sensor straight and slowly.
SST 09830–36010, 09950–60010 (09951–00650),
F08658
09950–70010 (09951–07100)
(See page
11. CONNECT SKID CONTROL SENSOR WIRE
(a) Connect the connector from the skid control sensor.
G23167
(See page 05–699)
http://vnx.su
30–31)
(See page 27–4)