Toyota Avensis ZZT251 2003 Service And Repair Manual page 905

16–48
39. INSTALL INTAKE MANIFOLD INSULATOR NO.1
SST
SST
AVENSIS REPAIR MANUAL (RM1018E)
COOLING – WATER PUMP ASSY (1CD–FTV)
(See page
40. INSTALL FUEL INLET PIPE SUB–ASSY
NOTICE:
Y
In case of having the water pump replaced, must re-
place fuel inlet pipe, too.
Y
When assembling the pipe, perform the operation
with the engine cold under room temperature.
(a) Temporarily install the new fuel inlet pipe.
A79148
(b) Using SST, tighten the nut of the fuel inlet pipe to the com-
mon rail side.
SST 09023–12700
Torque:
42 N m (428 kgf cm, 31 ft lbf) for a used pipe using SST
46 N m (469 kgf cm, 34 ft lbf) for a used pipe not using
SST
31 N m (316 kgf cm, 23 ft lbf) for a new pipe using SST
34 N m (347 kgf cm, 25 ft lbf) for a new pipe not using
A79149
SST
HINT:
Y
Use a torque wrench with a fulcrum length of 30 cm
(11.81 in.)
Y
Check if the used pipe has deflection or is installed prop-
erly after inlet pipe is reassembled. If there is deflection
or if it can not be installed properly, replace the used pipe
with a new pipe.
(c) Using SST, tighten the nut of the fuel inlet pipe to the injec-
tion pump side.
SST 09023–12700
Torque:
42 N m (428 kgf cm, 31 ft lbf) for a used pipe using SST
46 N m (469 kgf cm, 34 ft lbf) for a used pipe not using
SST
31 N m (316 kgf cm, 23 ft lbf) for a new pipe using SST
34 N m (347 kgf cm, 25 ft lbf) for a new pipe not using
SST
HINT:
Y
Use a torque wrench with a fulcrum length of 30 cm
(11.81 in.)
Y
Check if the used pipe has deflection or is installed prop-
erly after inlet pipe is reassembled. If there is deflection
or if it can not be installed properly, replace the used pipe
with a new pipe.
http://vnx.su
11–69)