Toyota Avensis ZZT251 2003 Service And Repair Manual page 643

1
8
4
6
2
110. INSTALL CLUTCH DISC ASSY (M/T TRANSAXLE)
111. INSTALL CLUTCH COVER ASSY (M/T TRANSAXLE)
112. INSTALL MANUAL TRANSAXLE ASSY (M/T TRANSAXLE)
113. INSTALL AUTOMATIC TRANSAXLE ASSY (A/T TRANSAXLE)
114. INSTALL FRONT DRIVE SHAFT ASSY LH
115. INSTALL FRONT DRIVE SHAFT ASSY RH
116. INSTALL FRONT SUSPENSION CROSSMEMBER W/CENTER MEMBER
(a) Install the engine mounting insulator FR with the through bolt and nut.
Torque: 87 N m (887 kgf cm, 64 ft lbf)
(b) Install the engine mounting insulator RR with the through bolt and nut.
Torque: 87 N m (887 kgf cm, 64 ft lbf)
117. INSTALL STARTER ASSY
118. INSTALL VANE PUMP ASSY
Torque: 37 N m (370 kgf cm, 27 ft lbf)
A
B
B B B
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(b) Install the drive plate. (A/T)
(1)
(2)
5
(3)
3
Torque: 98 N m (1,000 kgf cm, 72 ft lbf)
(c) Install the flywheel. (M/T)
7
(1)
(2)
A77403
Torque: 130 N m (1,327 kgf cm, 96 ft lbf)
NOTICE:
Do not reuse the flywheel bolt.
(See page
(See page
(See page 19–12)
119. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
(a) Install the 2 bolts and 2 nuts as shown in the illustration.
Torque:
Bolt 45 N m (459 kgf cm, 33 ft lbf)
Nut 133 N m (1,356 kgf cm, 98 ft lbf)
A63273
(b) Install the front suspension member braces with the 8
bolts.
Torque:
A
Bolt A 133 N m (1,356 kgf cm, 98 ft lbf)
B
Bolt B 80 N m (816 kgf cm, 59 ft lbf)
B
A77404
http://vnx.su
– PARTIAL ENGINE ASSY (1AZ–FE)
Clean the bolt and bolt hole.
Apply adhesive to the bolts.
Using several steps, install and tighten the 8 bolts
uniformly in the sequence shown in the illustration.
Clean the bolt hole.
Using several steps, install and tighten the 8 bolts
uniformly in the sequence shown in the illustration.
(See page 42–26)
(See page 42–26)
(See page
(See page
30–6)
30–6)
14–131
41–24)
40–25)