Table of Contents
Advertisement
32–14
8.
REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB–ASSY
(a)
Using a screwdriver, remove the screw from the brake master cylinder.
(b)
Remove the brake master cylinder reservoir sub–assy and 2 brake master cylinder reservoir grommets
from the brake master cylinder.
(c)
Remove the cap and strainer from the master cylinder reservoir.
Grommets
Retainer
Washer
Lithium soap base glycol grease
AVENSIS REPAIR MANUAL (RM1018E)
BRAKE
–
BRAKE MASTER CYLINDER SUB–ASSY
7.
REMOVE BRAKE MASTER CYLINDER SUB–ASSY
(RHD STEERING POSITION TYPE)
(a)
Disconnect the brake fluid level switch connector.
(b)
M/T transaxle:
Slide the clip and disconnect the clutch reservoir tube.
(c)
w/o VSC:
Using SST, disconnect the 2 brake lines from the brake
master cylinder sub–assy.
SST
09023–00100
(d)
w/ VSC:
Using SST, disconnect the 2 brake lines from the brake
master cylinder sub–assy.
SST
09023–38400
G24225
(e)
Remove the 2 nuts and pull out the accelerator control
cable support and brake master cylinder sub–assy.
(f)
Remove the O–ring from the brake master cylinder sub–
assy.
F45394
9.
INSTALL BRAKE MASTER CYLINDER RESERVOIR
SUB–ASSY
(a)
Apply lithium soap base grycol grease to the 2 brake mas-
ter cylinder reservoir grommets.
(b)
Install the retainer washer to the brake master cylinder.
(c)
Install the 2 brake master cylinder reservoir grommets to
the brake master cylinder.
(d)
Using a screwdriver, install the brake master cylinder re-
sevoir sub–assy with the screw.
F45395
http://vnx.su
Advertisement
Table of Contents
