Toyota Avensis ZZT251 2003 Service And Repair Manual page 699

A
B
A
B
B
B
122. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
123. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 RH
HINT:
Perform the same procedure as above on the opposite side.
124. INSTALL FRONT STABILIZER LINK ASSY LH
125. INSTALL FRONT STABILIZER LINK ASSY RH
HINT:
Perform the same procedure as above on the opposite side.
126. INSTALL TIE ROD END SUB–ASSY LH
127. INSTALL TIE ROD END SUB–ASSY RH
HINT:
Perform the same procedure as above on the opposite side.
128. INSTALL FRONT AXLE HUB LH NUT
129. INSTALL FRONT AXLE HUB RH NUT
HINT:
Perform the same procedure as above on the opposite side.
130. INSTALL EXHAUST PIPE ASSY FRONT
131. INSTALL FLOOR PANEL BRACE FRONT
Torque: 30 N m (306 kgf cm, 22 ft lbf)
132. INSTALL STEERING INTERMEDIATE SHAFT
133. INSTALL GENERATOR ASSY
134. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING)
HINT:
Y
1ZZ–FE (See page
Y
3ZZ–FE (See page
135. INSTALL CLUTCH RELEASE CYLINDER ASSY (M/T TRANSAXLE)
(See page 41–15)
136. INSTALL FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT (A/T TRANSAXLE)
(See page 40–11)
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(e)
A
B
A76717
(f)
A
NOTICE:
When installing the crossmember, check that the position-
ing holes on the crossmember and on the vehicle are
B
B
B
aligned with each other.
A76716
(See page
(See page
55–74)
55–70)
http://vnx.su
– PARTIAL ENGINE ASSY (1ZZ–FE/3ZZ–FE)
Tighten the 2 bolts and 2 nuts.
Torque:
45 N m (459 kgf cm, 33 ft lbf) for Bolt A
133 N m (1,356 kgf cm, 98 ft lbf) for Nut B
Install the front suspension member brace LH and RH
with the 8 bolts.
Torque:
133 N m (1,356 kgf cm, 98 ft lbf) for Bolt A
80 N m (816 kgf cm, 59 ft lbf) for Bolt B
(See page 30–6)
(See page 30–6)
30–6)
(See page 15–2)
(See page 50–9)
19–7)
14–43
(See page 30–6)