Toyota Avensis ZZT251 2003 Service And Repair Manual page 713

Cut Position
SST
11. INSTALL FAN AND GENERATOR V BELT
SST 09249–63010
12. INSTALL ENGINE COVER SUB–ASSY NO.1
Torque: 7.0 N m (71 kgf cm, 62 in. lbf)
13. INSTALL FRONT WHEEL RH
Torque: 103 N m (1,050 kgf cm, 76 ft lbf)
14. CHECK FOR ENGINE OIL LEAKS
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL –
8. REMOVE TIMING GEAR CASE OR TIMING CHAIN
CASE OIL SEAL
(a) Using a screwdriver with tip wrapped in the tape, pry out
the oil seal.
HINT:
After removal, check if the crankshaft is not damaged.
If it is damaged, smooth the surface with 400–grit sandpaper.
A77418
9. INSTALL TIMING GEAR CASE OR TIMING CHAIN
CASE OIL SEAL
(a) Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip off foreign materials.
SST
(b) Using SST and a hammer, tap in the oil seal until its sur-
face is flush with the rear oil seal retainer edge.
SST
NOTICE:
A77419
Wipe off extra grease on the crankshaft.
10. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the pulley.
(b) Using SST, install the pulley bolt.
SST
Torque: 170 N m (1,733 kgf cm, 125 ft lbf)
SST
A77420
(See page
http://vnx.su
TIMING GEAR CASE OR TIMING CHAIN CASE OIL
SEAL (1AZ–FE)
09223–22010
09213–54015 (91651–60855), 09330–00021
14–105)
14–179