Disconnect
Pin
Hook
Plunger
Push
Turn
Seal Packing
A
A
C
B
A
Nut
19.
INSTALL IGNITION COIL ASSY
Torque: 9.0 N m (92 kgf cm, 80 in. lbf)
20.
CHECK FOR ENGINE OIL LEAKS
21.
INSTALL ENGINE COVER SUB–ASSY NO.1
Torque: 7.0 N m (71 kgf cm, 62 in. lbf)
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(c)
Turn
A77396
(d)
18.
(a)
A77397
(b)
NOTICE:
S
S
S
A77399
(c)
A
B
Nut
A
A77400
http://vnx.su
–
CAMSHAFT (1AZ–FE)
Turn the crankshaft counterclockwise, and check that the
pin is disengaged from the hook.
Turn the crankshaft clockwise, and check the plunger is
extended.
INSTALL CYLINDER HEAD COVER SUB–ASSY
Remove any old seal packing (FIPG) material.
Apply seal packing to the 2 locations as shown in the il-
lustration.
Seal Packing: Part No. 08826–00080 or equivalent
Remove any oil from the contact surface.
Install the cylinder head cover within 5 minutes after
applying seal packing.
Do not expose the seal to engine oil 2 hours after
installing.
Install the cylinder head cover with the 8 bolts and 2 nuts.
Torque:
Bolt A 11 N m (112 kgf cm, 8.0 ft lbf)
Bolt B 14 N m (143 kgf cm, 10 ft lbf)
Bolt C 21 N m (214 kgf cm, 15 ft lbf)
Nut
11 N m (112 kgf cm, 8.0 ft lbf)
14–177