Toyota Avensis ZZT251 2003 Service And Repair Manual page 389

Push
1
2
AVENSIS REPAIR MANUAL (RM1018E)
FUEL
30.
(a)
NOTICE:
Y
Y
Retainer
A81618
31.
32.
33.
34.
35.
36.
37.
(a)
If the free length is less than minimum, replace the compression
A77857
spring.
(b)
New Gasket
(c)
(d)
(e)
(f)
(g)
A78440
38.
(a)
If the free length is less than minimum, replace the compression
spring.
A77857
http://vnx.su
– FUEL TANK ASSY (GASOLINE)
CONNECT FUEL TANK MAIN TUBE SUB–ASSY
Push in the fuel tube connector to the pipe until it makes
"click" sound, and then push up the retainer to the claws
lock.
Check if there is any damage or foreign objects on the
connected part.
After connecting, check if the fuel tube connector and
the pipe are securely connected by pulling on them.
CONNECT FUEL TANK RETURN TUBE (1AZ–FSE
ENGINE TYPE)
CONNECT FUEL TANK TO FILLER PIPE HOSE
CONNECT BREATHER TUBE FUEL HOSE
INSTALL PARKING BRAKE CABLE ASSY NO.3
Torque: 5.0 N m (51 kgf cm, 44 in. lbf)
INSTALL PARKING BRAKE CABLE ASSY NO.2
Torque: 5.0 N m (51 kgf cm, 44 in. lbf)
INSTALL FUEL TANK PROTECTOR NO.1
Torque: 5.4 N m (55 kgf cm, 48 in. lbf)
INSTALL EXHAUST
(1ZZ–FE/3ZZ–FE ENGINE TYPE)
Compression spring inspection
(1) Using vernier calipers, measure the free length of
the compression spring.
Minimum length:
41.5 mm (1.634 in.) for front x manifold
38.5 mm (1.516 in.) for front x tail
Install each new gasket to the exhaust manifold and the
exhaust pipe front as shown in the illustration.
Install the exhaust pipe front to the 2 exhaust pipe sup-
ports
Tighten the 4 compression springs and 4 bolts.
Torque: 43 N m (440 kgf cm, 32 ft lbf)
Install the grommet. (w/o HID Sensor)
Connect the heated oxygen sensor connector.
Install the floor carpet with the 2 clips. (w/o HID Sensor)
INSTALL EXHAUST
(1AZ–FE/1AZ–FSE ENGINE TYPE)
Compression spring inspection
(1) Using vernier calipers, measure the free length of
the compression spring.
Minimum length: 38.5 mm (1.516 in.)
11–99
PIPE ASSY CENTER
PIPE ASSY CENTER