Toyota Avensis ZZT251 2003 Service And Repair Manual page 845

19–14
SST
1 – B
SST 2
SST
1 – A
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
STARTING & CHARGING –
(b) Install the rear end cover with the 2 nuts.
Torque: 4.4 N m (45 kgf cm, 39 in. lbf)
(c) Install the terminal plate with the screw and nut.
Torque:
Bolt 3.9 N m (40 kgf cm, 35 in. lbf)
Nut 4.4 N m (45 kgf cm, 39 in. lbf)
(d) Install the terminal insulator withe the nut.
Torque: 4.1 N m (42 kgf cm, 36 in. lbf)
14. INSTALL GENERATOR PULLEY
SST
1 – A
SST
HINT:
SST1 – A, B
SST2
(a) Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
(b) Hold SST 1 – A with a torque wrench, and tighten SST 1
A62753
– B clockwise to the specified torque.
Torque: 39 N m (398 kgf cm, 29 ft lbf)
NOTICE:
Check that SST is secured to the pulley shaft.
(c) Mount SST 2 in a vise.
(d) Insert SST 1 – A, B into SST 2, and attach the pulley nut
to SST 2.
A62754
(e) Tighten the pulley nut, turn SST 1 – A in the direction
shown in the illustration.
Torque: 111 N m (1,132 kgf cm, 82 ft lbf)
(f) Remove the alternator form SST 2.
A62765
http://vnx.su
GENERATOR ASSY (1ZZ–FE/3ZZ–FE)
09820–63010 (09820–06010, 09820–06020)
09820–06010
09820–06020