Toyota Avensis ZZT251 2003 Service And Repair Manual page 842

2. REMOVE GENERATOR BRUSH HOLDER ASSY
(a) Remove the nut and terminal insulator.
(b) Remove the screw, nut and terminal plate.
(c) Remove the 2 nuts and rear end cover.
(d) Remove the brush cover from the brush holder.
(e) Remove the 2 screw and brush holder.
3. REMOVE GENERATOR REGULATOR ASSY
(a) Remove the 3 screws and regulator.
4. REMOVE GENERATOR HOLDER W/RECTIFIER
(a) Remove the 4 screws and holder w/ rectifier.
SST
F
E
1ZZ–FE,3ZZ–FE ENGINE REPAIR MANUAL
(RM923E)
STARTING & CHARGING
5.
(a)
(b)
(c)
(d)
A62757
6.
(a)
B
A62881
(b)
F
A62882
http://vnx.su
– GENERATOR ASSY (1ZZ–FE/3ZZ–FE)
REMOVE GENERATOR ROTOR ASSY
Remove the plate seal from the rectifier end frame.
Remove the 4 terminal insulator, 4 nuts and cord clip.
Using SST, remove the rectifier end frame.
SST 09286–46011
Remove the rotor from drive end frame.
INSPECT GENERATOR REGULATOR ASSY
Using an ohmmeter, check the continuity between termi-
nals F and B.
Standard:
When the positive and negative poles between termi-
nals F and B are exchanged, there is continuity in one
way but no continuity in another way.
Using an ohmmeter, check the continuity between termi-
nals F and E.
Standard:
When the positive and negative poles between termi-
nals F and E are exchanged, there is continuity in one
way but no continuity in another way.
19–11