Table of Contents
Advertisement
14–322
5
2
1
8
7
14
13
15
43.
INSPECT VALVE CLEARANCE
44.
ADJUST VALVE CLEARANCE
Seal Width
2 to 4 mm
Seal Packing
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(e)
Seal Packing
A09601
A09627
11
10
12
4
6
9
3
A09650
(See page
(See page
45.
(a)
(b)
A09600
http://vnx.su
–
CAMSHAFT (1CD–FTV)
Install the camshaft bearing caps.
(1)
Remove any oil packing (FIPG) material from the
No. 5 camshaft bearing cap.
(2)
Apply seal packing to the No. 5 camshaft bearing
cap as shown in the illustration.
Seal packing: Part No. 08826–00080 or equivalent
(3)
Place the 5 bearing caps in their proper locations.
(4)
Using several steps, install and tighten the 15 bear-
ing cap bolts uniformly in the sequence shown in the
illustration.
Torque: 20 N m (204 kgf cm, 15 ft lbf)
14–270)
14–270)
INSTALL CAMSHAFT OIL SEAL RETAINER
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the oil seal
retainer and the cylinder block.
(1)
Thoroughly clean all components to remove all the
loose material.
(2)
Using non–residue solvent, clean both sealing sur-
faces.
Apply seal packing to the oil seal retainer as shown in the
illustration.
Seal packing: Part No. 08826–00080 or equivalent
(1)
Install a nozzle that has been cut to a 2 to 4 mm
(0.08 to 0.16 in.) opening.
(2)
Parts must be assembled within 15 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
(3)
Immediately remove nozzle from the tube and rein-
stall the cap.
Advertisement
Table of Contents
